No-heat Regeneration Adsorption Dryer (no-heart dryer) is an adsorption drring & purification
- Model
- ZLD
Item specifics
- Air Processing Capacity
- 1〜500Nm3/min
- Operating Pressure
- 0.6〜1.0MPa
- Air Inlet Temperature
- ≤45°C
- Dew Point of the Finished Product Gas
- -40°C〜-70°C
- Switching Time
- 10min (adjustable)
- Pressure Drop Between Air Inlet and Outlet
- ≤0.021MPa
- Regeneration Mode
- No-heat regeneration
- Power Supply
- AC220V/1P/50Hz,
- Environmental Temperature
- ≤45°C
Review
Description
The no-heat adsorption regeneration dryer (no-heat dryer) is an adsorption drying & purification device. It uses the pressure swing adsorption principle to remove the water in the air, so as to achieve the purpose of drying the air. The no-heat regeneration dryer utilizes the characteristic that the porous surface of the adsorbent may select to carry out adsorption for some components, so that the water in the air is adsorbed to the pore of the adsorbent, in order to eliminate the water in the air. After the adsorbent is operated for a certain time, the adsorbent becomes saturated to achieve adsorption equilibrium. It is required to use the drying gas under the near normal pressure to regenerate the adsorbent, so as to recover the adsorption capacity of the adsorbent. As the adsorbent may be repeatedly used for adsorption and regeneration, the no-heat regeneration dryer may be carried out the continuous, safe and reliable operation. The no-heat regeneration dryer is mainly composed of the following devices including two adsorption towers available for being alternatively used, one muffler, one set of switch valves, one control system and gas source processing unit.
Air Processing Capacity: 1 ~500Nm3/min
Operating Pressure: 0.6-1.OMPa (able to provide the product in the range of 1.0~3.0MPa according to the user requirements)
Air Inlet Temperature: W45°C (Min 5P)
Dew Point of the Finished Product Gas: -40°C~-70°C (dew point under the normal pressure) Switching Time: 10min (adjustable)
Rated Power: 100w
Pressure Drop Between Air Inlet and Outlet: W0.021 MPa
Gas Consumption for Regeneration: W12% rated processing capacity
Regeneration Mode: No-heat regeneration
Power Supply: AC 220v/1P/50Hz
Environmental Temperature: W45P